Yes, it can be connected, but in addition to a new M-series Mac, you will need to use a splitter. We also have a user manual specifically for the Mac system available.

1. First, please check in Device Manager that the serial port device is recognized. 2. In the CNC machine settings of the connection software, please confirm that the COM port and baud rate settings are correct. Once these are confirmed, you can establish a connection.

You can use the manual tool setting method. Specifically, start the spindle, carefully lower the tool to make slight contact with the workpiece surface, and create a light mark. Once contact is confirmed, set the current position as the zero point.

The USB drive contains host software. It is also compatible with software that supports GRBL (such as Easel, UGS, GSender, and Candle).

It is normal for the Z-axis to move slower than the X and Y axes. Increasing the Z-axis speed too much may cause it to lose steps, so adjustment is not recommended.

1. Check the wiring. 2. Check the data cable connection.

The motherboard cannot connect to Wi-Fi.

If you have not changed the parameters during operation, the speed depends only on the toolpath settings. If you have accidentally changed the parameters, please contact LUNYEECNC Customer Service.

The content at the link is the same as the content on the USB drive. Please download the content from the link.

Please check if laser mode is enabled (32=1 indicates that laser mode is on). If it is enabled, please disable it manually.

Please refer to the MAC User Guide.

Please refer to the MAC usage guide.